Buy ASTM D CLASSIFICATION FOR MACHINE-MADE ‘ FIBERGLASS’ (GLASS-FIBER-REINFORCED THERMOSETTING-RESIN) PIPE from SAI. Find the most up-to-date version of ASTM D at Engineering This classification covers machine-made “fiberglass” (glass-fiber-reinforced thermosetting-resin) pressure pipe. Methods of classification.
|Published (Last):||25 October 2018|
|PDF File Size:||1.58 Mb|
|ePub File Size:||18.56 Mb|
|Price:||Free* [*Free Regsitration Required]|
The outside diameter of the? This cell-type format, however, is subject to misapplication since unobtainable property combinations can sstm selected if the user is not familiar with commercially available products. Note 2 — There is no known ISO equivalent to this standard.
Benton, Ar Cell: Note 1 — For the purposes of this standard, polymer does not include natural polymers. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. NOTE 3—All possible pressure strength combinations of types, grades, and classes may not be commercially available.
It covers the following types, grades, and classes of machine-made? Pipe meeting this classi?
The values in parentheses are provided for information only. The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in astk standard.
Changes in materials or manufacturing processes will necessitate a screening evaluation as described in Practice D Precedence for this change has been made in other ASTM standards.
Current edition approved June 10, This standard does not purport to address all of the safety concerns, if any, associated with its use. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters.
Table 1 data was divided into 4 Parts for spacing considerations. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Stay on Page Continue to Compass. Standard categories for the hydrostatic design basis are shown in Table 1. For the second generator, the property must be supplied by the FRP fiberglass pipe manufacturer in order to generate the ASTM D designation code for the piping.
Form Box Generator Site. Formerly under the jurisdiction of Committee D20 on Plastics, this standard was withdrawn in August Link to Active This link will always route to the current Active version of the standard.
Or the D Zstm 1 data can be used to explain how the classification designation code for composite fiberglass piping is derived. Methods of classification, requirements, test methods and the method of marking are included. There are two designation code d23110 look up scripts using the ASTM D standard classification. The inside diameter of the? It is not based on dimensions or raw material specifications.
D231 script was ‘debugged’ to the best of our ability! The manufacturer should be consulted. NOTE 5—Information regarding selection of service design factors and pressure rating is provided in Practice D and the individual product standards.
The manufacturer should be consulted. Two methods of classifying long-term strength are included: It is not based on dimensions or raw material speci? NOTE 1—For the purposes of this standard, polymer does not include natural polymers. This standard does not purport to address all of the safety concerns, if any, associated with its use.
Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. This standard has been approved for use by agencies of the Department of Defense. It is the responsibility of the user of this standard r2310 establish appropriate safety ast health practices and determine the applicability of regulatory limitations prior to use.
Table 1 sstm a summary of the designation requirements. A hydrostatic design basis as shown in Table 1 shall be determined for each type, grade, and class of product manufactured.