ASTM C1090 PDF

Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C/CM: Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout.

Author: Yolar Tezahn
Country: Dominica
Language: English (Spanish)
Genre: Health and Food
Published (Last): 1 June 2016
Pages: 463
PDF File Size: 8.13 Mb
ePub File Size: 12.15 Mb
ISBN: 684-7-57385-782-9
Downloads: 8761
Price: Free* [*Free Regsitration Required]
Uploader: Kelmaran

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently asm the other.

Newer Post Older Post Home. Though not recommended by the ASTM standards, and in order to provide the lowest friction possible, an acetate sheet was used in between the test specimen and the mold.

Referenced Documents purchase separately The documents listed below are referenced within the aztm standard but are not provided as part of the standard. These test methods cover astj for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-s Some values have only SI units because the inch-pound equivalents are not used in practice.

Link to Active This link will always route to the current Active version of the standard.

  FORTRON FSP180-50LE PDF

ASTM C1090

The height change results in both test methods are expressed in terms of percentage increase or decrease of the original specimen height. The height change of a 3-inch mm -diameter by 6-inch mm -tall cylindrical specimen was measured in accordance with ASTM C For cementitious grouts, saturate the surface up to SSD.

Testing of shrinkage for concrete – grout. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. This approach provided more simplicity in the execution of the test, rather than using a projector lamp, magnifying lens, and indicator charts as described in ASTM C see figure The degree of restraint varies with the mixture viscosity and degree of hardening.

ASTM International – Standard References for ASTM C / CM – 15

aastm Two cylindrical specimens with the same dimensions as those used for the ASTM C test method were prepared in which the change in height was measured at four points on the top surface of the specimens using a micrometer in accordance with ASTM C at 1, 3, 7, 14, and 28 d see figure This thickness was then added to the four-reading initial measurement.

  DESCARGAR BASES CURRICULARES DE LA EDUCACION PARVULARIA PDF

The laser approach has been compared with the original setup, and similar results were obtained.

In both test methods, there is always a certain degree of friction between the specimen’s sides and the inner surface of the metallic mold. Sieve size is identified by its standard designation in Specification E Historical Version s – view previous versions of standard.

The glass plate was removed from the top of the test specimen after 24 h. Combining values from the two systems may result in non-conformance with the standard. After removal, the thickness c109 the glass plate was measured with a caliper at the points of contact between the glass plate and the micrometer.

I married on 30 th June now having one b An exception is made when the options described in the section on test conditions are exercised. The alternative designation given in parentheses is for information only and does not represent a different standard sieve size.